Tracking settings are different
between the ZT260 and the normal ZT.
Most tyre factors don't
realise this and some will argue with you until you produce a print out
from the ZT260 workshop manual.....
The data here is from my copy of the 260 training notes and confirmed
by Scooter from Dreadnought as the later factory settings.
Front toe total +0deg 12' +-0deg 6' (6 minutes per side!)
Front camber -1deg10' +-0deg 15'
rear toe total 0deg 36' +- 0deg 6' (18 minutes per side!)
rear camber -2deg 05' +-0deg 15'
Thrust 0deg 00' +-0deg 6'
If you have problems like the front outer outer edges of the tyres wear
first, you need to get the car checked by someone who has the correct
four wheel kit, you need to make sure the rear is correct and the
thrust line is correct before looking at the front tracking. Does the
car pull to the right, do you make a sharp turn to the right such as a
right turn into your home or work as these could be the cause. It could
be that you have not enough camber on that side or there is a bent hub
carrier or suspension arm. A good four wheel kit with a good operator
should be able to find the fault if you tell him why you want it
checked.
And just in case!
Tyre pressures Front 34 psi Rear 36 psi